Skip to main content
8x8 Support

Bogen PCM-TIM Overhead Paging System Configuration

Important-Icon.png You must connect the 8x8 adapter to a Tel Line or 90v NGT RNG port before configuring the Bogen PCM-TIM Overhead Paging System.  Refer to the Bogen Instalation manuals here

Objective

Configuring a Bogen PCM-TIM overhead paging system for 8x8 services.

Applies To

Bogen PCM-TIM overhead paging system (FXS Mode Only)

Bogen PCM Series

There are 3 Bogen PCM models and differing version releases.  Refer to this link to few Here

Procedure

Important-Icon.png

There are two versions or Hardware revisions of the Bogen PCMTM.  Refer to the images below step 3 to identify the revision being configured.  Both of the images are FXS Only.  Follow the Bogem Manual for proper instalation

  1. Ensure that only DIP Switch 6 is ON Version 1.
  2. Ensure that DIP Switch is set to Station Version 2
  3. Using the phone line or RJ11 cable, connect your 8x8 adapter to the Tel Line (v1) or 90v NGT RNG (V2) port.
Version 1 Version 2
Bogen_PCM_TIM_Paging_Config.png PCMTIM2.jpg
 
 
  • Was this article helpful?
/**/