Skip to main content
8x8 Support

How to Setup Static IP on a D-Link DIR-655 Router

Note-Icon.png

Note: We highly recommend consulting an IT or network professional when configuring advanced network settings. If able, the network administrator should always check the IP address, and assign and log any static IP to avoid conflicts in the future.

Objective 

Set up a D-Link DIR-655 QoS router, to use a static IP for the WAN.

Applies To

  • D-Link DIR-655 router 

Procedure

Important-Icon.png

Before you begin:

Gather all of the following (contact your ISP if you do not have this information):

  • IP Address
  • Subnet Mask
  • Gateway Address
  • Primary DNS Address
  • Secondary DNS Address
  1. Access the router web interface (GUI).
  2. In the left hand menu, click Internet.
  3. Click the Internet Connection Setup Wizard button.
    D-Link StaticIP-Setup1-550x409.jpg
  4. On the initial Connection Setup Wizard screen, click Next.
    D-Link StaticIP-Setup2-550x246.jpg
  5. Set and verify an administrator password. (Note this password for later reference.)
    D-Link StaticIP-Setup3-550x232.jpg
  6. Select a time zone and click Next.
    D-Link StaticIP-Setup4-550x205.jpg
  7. On the Configure Your Internet Connection screen, select Static IP Address Connection and click Next.
    D-Link StaticIP-Setup5-550x459.jpg
  8. Enter all of the required information for you Static IP Address Connection and DNS Settings, then click Next.
    D-Link StaticIP-Setup6-550x316.jpg
  9. On the Setup Complete! screen, click Connect.
    D-Link StaticIP-Setup7-550x218.jpg
  10. On the Reboot Needed screen, choose whether to reboot now or later. Your router must reboot for your new settings to take effect.
    D-Link StaticIP-Setup8-550x333.jpg

 

  • Was this article helpful?