Skip to main content
How do I configure my Netgear FVS338 router for 8x8 service?
8x8 Support Knowledge Base

How do I configure my Netgear FVS338 router for 8x8 service?

Netgear FVS338 Router

Note: This router is designed to support larger networks.

netgear fv.png

Administrative Information

  1. Make sure your router is powered on and connected to your network.
  2. In a browser on a computer on the same network as the router, navigate to the following IP address: 192.168.1.1.
  3. Log in (default credentials shown below).
    • Username: admin
    • Password: password

Tested on firmware version 3.0.6-25.

Adding/editing 8x8 subnets is recommended when available. Please click here and review the Traffic Shaping and Specific Subnet/Port Configuration section. (Login required.)


Configure Port Settings

  1. Select Security > Services.
  2. Configure the ports as listed here in the Traffic Shaping and Specific Subnet/Port Configuration section. (Login required.)
    netgear services.png

Firewall Configuration

  1. Go to Security > Firewall.
  2. Go to the LAN WAN Rules tab.
  3. Set your Default Outbound Policy to Allow Always.
  4. Configure settings for you Outbound Services.
    netgear fv firewall.png 

Disable SIP ALG

  1. Go to Security > Firewall > Advanced (SIP-ALG).
  2. Ensure the box next to Enable SIP ALG is unchecked.
  3. Click Apply.
    netgear alg.png

QoS Configuration

  1. Go to Security > Bandwidth Profile.
  2. Set your bandwidth values accordingly (available bandwidth will vary).
    netgear bandwidth.png