Skip to main content
Yealink W52P DECT Phones: How to factory reset
8x8 Support Knowledge Base

Yealink W52P DECT Phones: How to factory reset

Objective

Reset Yealink DECT Base Station to Factory Defaults

Applies To

Yealink W52P / W52H, Yealink W60P / W56H

Procedure

 

  1. Power off the unit - if powered by PoE this might mean unplugging the network cable.
  2. Wait 15 seconds.
  3. Press and hold the connect button on the base station.
  4. Reconnect the power.
  5. Wait until all 3 status lights are on, showing solid green.
  6. Release the button and wait 5 minutes.
  7. Power off the unit.
  8. Wait 15 seconds.
  9. Reconnect the power.
  10. Your phone may update it's configuration after the reboot which may result in a second reboot process automatically within a minute or two of the first reboot.

*Please note that you'll need to re-pair the handset after resetting the base station back to factory defaults to get the base IP address.*

 

 

  • Was this article helpful?