Skip to main content

 

 
8x8 Support

How to Pair a Yealink W52P Handset with Base Station

Objective

Pairing a Yealink W52P handset with the base station.

Applies To

  • Yealink W52P DECT Handset

Procedure

  1. When the handset LCD screen prompts “Press base paging 2s then press Reg.,” long press the Wireless button on the base station until the registration LED flashes.
  2. Press the OK soft key on the handset.
  3. Select Register Handset.
  4. Select the desired base and then press the OK soft key. The handset begins searching the base.
  5. Press the OK soft key after searching a base successfully.
  6. Enter the base PIN (default: 0000), and then press the Done soft key to complete registration.

Note: You can also press the OK key to enter the main menu, and then select Settings > Registration > Register Handset and repeat steps 2-4 to register multiple base stations.

After successful registration, the handset LCD screen prompts “Handset Subscribed” and “Base NO. (The last 4 characters of connected Base’s MAC address).” If the handset LCD screen prompts “Searching for Base,” check if your base station is powered on.

  • Was this article helpful?