How do I configure my Linksys Router?
To configure your Linksys Router, first log in to your router, then navigate to the Security section. Read more for the full steps to configure your router.
The purpose of this article is to provide a sample configuration. At the time of article creation, this device was in a known working state on the firmware used.
Keep in mind different firmware versions will interact with hosted VoIP services in different ways. While this device may be fully functional on the tested and/or current firmware version, it is possible newer revisions will cause disruptions in service or make a device fully compliant with the required settings for hosted VoIP services where it was previously not.
Objective
Configure Linksys Router for 8x8 Service
Applies To
All Linksys EA Series routers
Procedure
- Obtain the username and password for the Linksys router.
- Default Credentials:
- Username: admin
- Password: admin
- Default Gateway: 192.168.1.1
- Default Credentials:
- After logging in, navigate to Security.
- Click Security and then disable SPI (Stateful Packet Inspection).
- By Default SIP ALG is disabled on these device, but it should be confirmed.
- Navigate to Connectivity.
- After Connectivity is opened up, click Administration and ensure SIP is disabled.
Known Issues
- Linksys EA Series devices have issues with NAT functionality when multiple phones are on the network. This will cause problems with misrouting of calls, device connectivity, and dropped calls. This is specific to lines without SRTP enabled. This behavior has been observed on all firmware revisions higher than 1.1.7.180968.
- For lines without SRTP enabled, setting the local SIP ports to unique port assignments will mitigate this issue, but it is not a long term solution.
- These devices will work fine with only one phone.