Skip to main content
How to Adjust Local SIP Ports
8x8 Support

How to Adjust Local SIP Ports

Objective

Adjusting local SIP ports.

Adjusting local SIP ports is commonly done when disabling Strict Register on a Fortigate router to resolve NAT configuration issues. Adjusting local SIP ports can also be completed as a last resort if a device is causing duplicate ports or port shuffling. If the local SIP ports are being adjusted, it needs to be completed for all phones on the same network.

Applies To

  • Polycom Devices 
  • Yealink Devices

Procedure

Polycom Phones

  1. In a browser on a computer on the same network as the phone, navigate to phone’s local IP address. You will need to enter https:// followed by the IP address. 
  2. Log in as Admin and enter the phone's MAC password.
  3. Click Settings.
  4. Click SIP.
  5. Enter a Local SIP Port. Typically we use ports 16000, 16001, 16002, etc.
    • Note: Do not assign ports below port 1024, as the lower ports are typically used by other applications. Additionally, If you are assigning a local SIP Port to more than one phone, each phone will need a unique port.
       
  6.  After setting the port assignment, click Save.
  7. If the phone does not take the configuration at first, reboot the device and try to assign the port again.

Yealink Phones

  1. Navigate to the Yealink login page.
  2. Log in using the following credentials.
    • Username: admin
    • Password: admin or MAC password
      yealink local 3-600x315.PNG
  3. Navigate to Settings > SIP.
  4. Modify the Local SIP Port.
    yealink local 2-600x600.PNG
  • Was this article helpful?