Configuring the Valcom V-9941A System

  1. Ensure that Switches SW1-1, SW1-2, and SW3 are OFF.
    Note: If you would prefer to have an audible tone precede each page, turn Switch SW1-1 ON.
  2. Connect the phone line or RJ11 cable to your 8x8 adapter.
  3. Use a wire cutter to strip the other end of the cable and attach the wires to the corresponding pins on the Valcom V-9941A (Example shows Cisco SPA122 adapter):
    • Red Wire (Ring): Pin 1
    • Green Wire (Tip): Pin 2
      Note: The black and yellow wires of the cable are not used.
  4. Connect the speaker to Pins 6 and 7 on the V-9941A.