The Viking PA-30 system:

  • Has 30 watts of output power.
  • Can support up to thirty (30) 8-ohm speakers.

Don't need this much power? You may be interested in the Viking PA-2A instead (2W output; supports up to three 8-ohm speakers).

Configuring the PA-30 System

  1. Turn ON DIP Switch 1 (OFF by default).
  2. Connect the phone line or RJ11 cable to your 8x8 adapter.
  3. Use a wire cutter to strip the other end of the cable and attach the wires to the corresponding pins on the PA-30:
    • Red Wire (Ring): Pin 9
    • Green Wire (Tip): Pin 10
      Note: The black and yellow wires of the cable are not used.
  4. Connect the speakers to Pins 1 and 2 and Pins 3 and 4 on the PA-30.