Skip to main content
How do I configure my Cisco (Linksys) RVS4000 router for 8x8 service?
8x8 Support Knowledge Base

How do I configure my Cisco (Linksys) RVS4000 router for 8x8 service?

Cisco (Linksys) RVS4000 Router

Note: Linksys has been acquired by Cisco, so this router may be referred to by either manufacturer.

Cisco Linksys.png

Administrative Information

  1. Make sure your router is powered on and connected to your network.
  2. In a browser on a computer on the same network as the router, navigate to the following IP address: 192.168.1.1.
  3. Log in (default credentials shown below).
    • Username: admin
    • Password: admin

Latest firmware: 2.0.3.2

Adding/editing 8x8 subnets is recommended when available. Please click here and review the Traffic Shaping and Specific Subnet/Port Configuration section. (Login required.)


Firewall Configuration

  1. Go to Firewall > Basic Settings
  2. Enable Firewall and Block WAN Request.
  3. Disable SIP Application Layer Gateway.
  4. Click Save.
    Cisco Firewall.png

QoS Configuration

  1. Go to QoS > Bandwidth Management.
  2. Enable Bandwidth Management.
  3. Enter the approximate upload speed in the Upstream box:
    • For DSL, use 80% of the maximum throughput.
    • For Cable or a dedicated line (T1), use 90% of the maximum throughput.
  4. Configure port priority.
  5. Enable these services.
  6. Click Save.
    Cisco QoS.png

Ports, Subnets, and DSCP Values for Cisco Routers

Here are some values users can add to their Cisco configuration file. If subnets are set to high priority or open, specific UDP traffic passing through those subnets does not need to individually be listed.

Under Class Definitions, add:

  • match access-group 2000
  • match access-group 2001
  • match access-group 2003

Under Access List Definitions, add:

  • access-list 2000 permit udp any any dscp ef
  • access-list 2001 permit udp any any dscp af31

  • access-list 2003 permit udp any 192.84.16.0 0.0.0.255
  • access-list 2003 permit udp any 192.84.18.0 0.0.0.255
  • access-list 2003 permit udp any 8.28.0.0 0.0.1.255
  • access-list 2003 permit udp any 217.163.57.0 0.0.0.255

  • access-list 2003 permit udp 192.84.16.0 0.0.0.255 any
  • access-list 2003 permit udp 192.84.18.0 0.0.0.255 any
  • access-list 2003 permit udp 8.28.0.0 0.0.1.255 any
  • access-list 2003 permit udp 217.163.57.0 0.0.0.255 any