Skip to main content
Panasonic KX-TGP600 Dect Phones: How to unpair Handset 1 using the GUI (web administration interface)
8x8 Support

Panasonic KX-TGP600 Dect Phones: How to unpair Handset 1 using the GUI (web administration interface)

Objective

Replacing the original handset (handset 1) paired to the base of a Panasonic unit when it has become inoperable.

Applies To

Panasonic KX-TGP600 DECT Phones

Procedure

Step One: Pair Replacement Handset

You will first need to pair the replacement handset to the base in order to enable Embedded Web for GUI access.

  1. Front facing the base unit, hold down the pairing button on the right hand side until the light indicator on the base goes to a steady flash.
  2. Hold down OK on the handset until the message moves from "Register Unit," to "Registering Unit."
  3. Once the new handset is paired, go to Menu > System Settings > Network Settings > turn on Embedded Web.

Step Two: Delete Original Handset

Next, you will need to access the Panasonic Web Interface (GUI) and delete the original handset 1.

  1. Obtain the handset's IP address by going to Menu > System Settings > Status > IPv4 Settings > IP Address.
  2. On a computer on the same network as the phone, open a web browser.  Internet Explorer preferred.
  3. In the browser address bar, enter: http:// followed by the IP address obtained above and press Enter. Example: http://10.192.110.212. This will take you to the Web GUI login page.
  4. Log in with the following credentials.
    • Username: instoperatorid
    • Password: qgENGet4GQKQVVRyYXJm4LQL2NGVuhEtKzK3Gkz7LdWZFvtxB7CHdWkpkD9Q8WZt
      clipboard_e9b9d1b4889b55bd05a70dac2247d2ea5.png
  5. From the starting page of GUI click on the System tab at the top, followed by Delete Handset in the right-hand menu.
  6. Select 1 & 2, then click ExecuteNote: Handset 2 is the new replacement and will need to be deleted in order to pair again as handset 1.
    clipboard_e9473f4638155b934b8c8829f28b6e6c9.png

Step Three: Pair Replacement Handset

Finally, you pair the replacement handset as handset 1.

  1. Front facing the base unit, hold down the pairing button on the right hand side until the light indicator on the base goes to a steady flash.
  2. The handset may require a complete power off and on. Go to Menu > System Settings > Register H/S > select Base.

 

  • Was this article helpful?