Skip to main content
Polycom IP 5000/6000/7000 Conference Phone Won't Power Up
8x8 Support Knowledge Base

Polycom IP 5000/6000/7000 Conference Phone Won't Power Up

Symptom

After plugging in your Polycom SoundStation IP 5000, IP 6000, or IP 7000 conference phone, it does not appear to turn on or draw power.

Applies To

Polycom IP 5000, 6000, and 7000 conference phones

Resolution

Using AC Power

PolycomConfPhonePOE-500x298.png

To connect the conference phone using AC power

Note: It is important that all cables are plugged in as shown above and described below—the 25-foot Ethernet cable must be plugged into the phone, and the power insertion cable to the end of the network cable and the network.
  1. Connect one end of the 25-foot Network Cable to the LAN jack on the phone.
  2. Connect the other end of the 25-foot Network Cable to the Power Insertion Cable.
  3. Connect the Power Insertion Cable to an available LAN port on the wall or hub/switch device port.
  4. Connect the Power Adapter to the Power Insertion Cable.
  5. Connect the Power Adapter (with the attached Regional Power Cord) to the wall outlet.

Using PoE

  1. Ensure the network and port you are plugging into support Power over Ethernet.
  2. Ensure you are using a PoE-ready Ethernet cord (such as the one packaged with the phone).

Cause

Most likely, the phone cabling is not properly plugged in, either using Power over Ethernet (PoE) or the optional AC power adapter (aka PoE injector).

PoE requires that the phone Ethernet cord be directly plugged into a network that support PoE using a PoE network cable (such as the 25-foot one that comes with the phone).

The AC power adapter requires the cords to be connected in a specific arrangement.

 

  • Was this article helpful?