Skip to main content
How to Configure WatchGuard Firebox T70
8x8 Support

How to Configure WatchGuard Firebox T70

Objective

Configure Watchguard Firebox T70 for 8x8 service

Applies To

Watchguard Firebox T70.  Tested version 12.3.B581846

Procedure

Add 8x8 Servers

  1. Go to Firewall and then to Aliases in the sub menu.
  2. When creating new Aliases fill in Name as 8x8 and Description as 8x8 Servers.
  3. Click Add under Alias Members.
    clipboard_e981a95f0230c9fdf8892a1fce01a23cf.png
  4. As Member type select Network IPv4
  5. Add all 8x8 subnets listed in the Virtual Office Technical Requirements
  6. After all 8x8 servers have been added, click Save.
    clipboard_ead6b72855d7eba8712a7d0178717d746.pngclipboard_e038ac6d2b74f55795d127c81874e7f77.png

Create Policy for 8x8

  1. Go to Firewall then to Firewall Policies and click Add.
  2. In the Packet Filter drop down choose Any, then click Add Policy.
    clipboard_e8b93bbc18e880b6127a7720a21b38db7.png
  3. In the From box click Add and select Any Trusted.
  4. In the To box click Add and select 8x8.
  5. Check the box next to Specify custom idle timeout and set to the timeout to 300 seconds. This helps to prevent dropped calls.
    clipboard_eb31dc569db942609df07acb2fb51a786.png
  6. Go to the Advanced tab.
  7. Select the options below to enable the following in the NAT section:
    • 1-to-1 NAT (Use Network NAT Settings)
    • Dynamic NAT
    • Select Use Network NAT Settings
  8. Click the checkbox next to Override Per-Interface Settings.
  9. Set the following values for QoS:
    • Marking Type: DSCP
    • Marking Method: Preserve
    • Prioritize Traffic Based on: Custom Value
    • Value: 7 (Highest)
  10. Click Save.
    clipboard_ee443c0f66f2401bf4200d498e17e833e.png
    clipboard_e2c169c527da387108a05afd5d5de8c21.png
  • Was this article helpful?